ATOM LEDs offer more than twice the brightness of halogen bulbs using the latest LED technology. Physically they are virtually the same size as the original bulb without any external driver boxes to mount, as the drivers are integrated inside the bulb. This simplifies the installation process and reduces any fitment issues during installation.

Our specially engineered aluminum body provides adequate cooling for the LED chips. Without the use of a fan or any moving parts to cool the bulb, there is reduced risk of failure due to dirt, water, ice etc. Integrated thermal protection circuitry is built in as an additional precaution to prevent overheating the LED chips. EMC circuitry is incorporated to prevent radio noise. Dual polarity circuitry offers convenience during installation so that knowing which wire is negative and positive is irrelevant.

ATOM LED bulbs can be used in both projector and reflector light assemblies, and can be clocked to fine tune the LED beam pattern.

1. Overall distance from base of bulb to outer edge of bulb is similar to halogen counterparts. This is important as some headlight assemblies may not have additional space behind the bulb for oversized fans and heat sinks.

2. Diameter of the bulb head is the same or smaller than its halogen counterpart to ensure it will fit into the headlight housing (particularly on H3, H1, and 800 bulb applications)

3. The length of the bulb head is similar to the glass length on a halogen bulb, avoiding situations where the bulb is too long to fit in the housing.

1. Push down on the collar / base of the bulb.

2. Turn the bulb inside the collar / base while pushing down.

To remove the collar, continue turning the bulb inside the collar / base until the teeth on the bulb aligns with the holes in the collar / base. Once aligned, you can slide the collar / base off the bulb.

For best focal beam pattern, adjust the bulb in the collar so that the LED chips are firing sideways.

This is a plug and play accessory that is sold separately. This device is used to:

• Turn off 'light out' warning indicators
• Complete a series wiring circuit
• Stop LEDs from flickering or turning on and off, due to the vehicle's computer thinking a light bulb is missing
• Other CANBUS related issues caused from converting halogens to ULTRA LEDs

*** Will not increase voltage or current for daytime running lights under 6V

Some vehicles may require special parts including:

• Bulb Holders (affects H7 & H1 bulbs)

• Harnesses (for daytime running light circuits under 6V)

• Resistors (for use with harnesses)

Although our LED bulbs are designed to fit into headlight housings with dust covers, we still offer universal round rubber dust covers that adds extra depth beyond the factory dust cap.

Available in different diameters (100mm, 95mm, 83mm, 75mm, 55mm)